Video summary
The 'Forbidden' Sailing Tricks That Makes the F50 Fly With No Wind
Main summary
Key takeaways
Getting an F50 Moving in Light Air
NorthStar SailGP trimmer Paul Campbell-James explains the challenge of getting an F50 moving when the water is nearly calm. With too little speed for the hydrofoils to lift the boat, the catamaran settles into displacement mode, with its hulls dragging through the water.
The crew aims to build enough speed and lift to progress from both hulls in the water (H2), through one-hull or assisted-lift modes (H1 and H1B), and finally into H0 foiling, when neither hull touches the surface.
Adjusting the Boat’s Setup
In very light air, the team uses its largest wing, measuring 27.5 metres, along with large rudders and centerboards. The bigger wing provides extra power, but also creates more drag. The crew trims it deeper—up to about 35 degrees of camber—and closes the sail’s twist to produce more sideways force and heeling moment, helping lift a hull.
The team also raises its largest staysail, the LA-1, to add power and help keep the boat heeled in H2 or H1. If the wind increases, the crew can switch to a smaller, faster staysail.
Crew Weight and Sail Control
Two crew members, usually the heaviest, leave the boat in light conditions, reducing its weight by about 200 kilograms. The flight controller can help work the sail controls while the boat is in H2 or H1, then return to their usual station when the team starts foiling.
With fewer hands available, Campbell-James must hold the sail’s position and control its twist himself. Crew members may also move to leeward to take weight off a hull and help tip the boat onto one side.
Building Speed and Lift
In H2, the crew can “twist pump” the sail—pulling and easing it to rock the boat and encourage it forward. SailGP rules allow this pumping, unlike restrictions common in other sailing. The technique works best at low speed and is less useful in windy conditions.
The crew can also lower and raise the centerboards. Lowering a board uses stored energy to drive its foil through the water, giving the boat a small forward push. To prevent damage, these movements are limited to three per minute on each wing.
A sharp board drop can help lift a hull during the transition from H2 to H1B. Once the hull rises, the foil angle can be adjusted to provide more lift.
Course Angle and Race Conditions
The best sailing angle changes as the wind fades. In H0, the boat can sail roughly 140 degrees downwind; in H1, it may need to sail at a sharper angle, around 115–120 degrees. H1 is generally faster than H2, so the crew tries to reach it—and then full foiling—as soon as conditions allow.
Turns cost precious speed. A tack or turn into the wind can nearly stop the boat, forcing the crew to rebuild its momentum. In crowded light-air racing, teams must also contend with turbulent “dirty” air from other boats and seek clearer wind near the edges of the course.
Key Takeaway
Even a calm-looking race demands constant decisions. Sail trim, crew weight, foil movements, course angle, and timing all matter as the team works to get the F50 back on its foils.
Presenter/source: Paul Campbell-James, NorthStar SailGP Team wing trimmer.
Rate this summary
Your feedback will help improve summaries.
Improve this summary
Reprocess with a stronger model when the summary feels incomplete or inaccurate.
Translate summary in another language
Ask questions to this video
Chat for follow-up questions, clarifications, and source-backed answers.