Video summary

Building Prototypes Dan Gelbart part 10 of 18 Flexures

Main summary

Key takeaways

Educational

Flexures: Design and Construction

Flexures are hinges and motion-guiding mechanisms made from thin, flexible sections of material. They are convenient to prototype from sheet metal using a waterjet and can replace conventional hinges, bearings, or guides when an application needs limited, precise movement.

Multi-stage elastic hinges

A classic flexure can be cut from a single block and designed with several lever stages to reduce motion. In the example, a 5:1 lever is combined with a 3:1 lever for a total reduction of 15:1. “Wiggle bars,” or swinging rods, separate each lever’s rotation from the straight-line movement needed by the next stage.

Precision and the cutting process

A waterjet alone may not produce pivot locations accurate enough for a straight stroke at the micron level. For a high-precision flexure, drill and ream the pivot holes first, then align the waterjet cuts to one of those holes.

The presenter demonstrates a design intended to provide about 2 mm of travel with a straightness deviation of up to 1 micron. A capacitive sensor and meter show movement in 10-nanometer increments without backlash.

Material choice

Material affects both stability and range of motion:

  • Aluminum is useful for demonstrations, but expands significantly with temperature. Even heat radiated from a nearby hand can shift the measured position.
  • Invar or quartz may be preferable when temperature stability matters.
  • Beryllium copper is also demonstrated. Waterjet-cut flexures can have narrow sections of about 0.3–0.4 mm.
  • Steel has a relatively limited elastic range. The presenter describes Nitinol as having an elastic range roughly ten times greater, enabling substantially more travel—about 20 mm in the example.

Assembling and tuning Nitinol flexures

In the demonstrated construction, Nitinol cannot be spot-welded, so each strip is clamped between stainless-steel pieces. The presenter recommends avoiding abrupt transitions, which can create stress concentrations.

The spring strips should be as consistent in length and stiffness as possible. A spacer can help keep the gaps uniform during assembly. The example uses eight springs, and how well they match affects the straightness of motion. If the assembled motion is not straight enough, individual springs can be adjusted—for example, by sanding them or otherwise changing their stiffness.

Checking straightness

A laser pointer aimed across a room makes small angular deviations visible as movement of the spot on a distant wall. For greater accuracy, an autocollimator measures angular motion by tracking light reflected from a mirror. Since angular motion is related to deviation from a straight path, the measured angle can be used to determine straightness error.

Cross-flexure joints

Two crossed flexible strips create a virtual pivot point at small angles, much like a conventional hinge. The example uses Nitinol and can bend through a large angle, though the fixed-pivot approximation applies only at small angles.

Flexures are best suited to applications that need movement between positions rather than continuous full rotation.

Advantages and Limitations

Flexures need no lubrication, making them useful in dirty or hard-to-service environments. Because they have no sliding or rolling contact, correctly designed flexures avoid wear-related backlash and can have a very long service life. They can also be integrated directly into a design and may be inexpensive to make from scrap sheet material when a waterjet is available.

Their main limitation is the material’s elastic range: if a flexure is bent beyond that range, it will remain permanently deformed. For long life, the presenter advises against using the full elastic range. As a rule of thumb, use no more than about two-thirds of it, and preferably stay below half. The safe limit varies by material.

Speaker

  • Dan Gelbart — presenter and demonstrator

Rate this summary

Your feedback will help improve summaries.

Improve this summary

Reprocess with a stronger model when the summary feels incomplete or inaccurate.

Pro

Translate summary in another language

Pro

Ask questions to this video

Chat for follow-up questions, clarifications, and source-backed answers.

Coming soon

Share this summary

Original video